Logic Supply ml100 Issue


#1

Hello - I’m trying to install a new Resin application on a Nuc-based Logic Supply ML100. I have used this Nuc in the past with Resin OS 2.2.0+rev1 (prod) and was able to install successfully. With my new app however, when I boot off the USB, I get stuck on the screen attached.

Any ideas?


#2

The most relevant message looks like the overlapping partitions one. If you plug the USB stick into a PC and run fdisk on it does the partition table look OK?


#3

I’ve tried 2 other USB sticks and get the same result for all. Anything else I can do to flash?


#4

Which version of resinOS are you having problems with?


#5

resin-…-2.2.0+rev1-v6.1.2


#6

Thanks. It sounds like that version has worked OK for you in the past, do you know what changes were made in between it working and failing?


#7

I tried installing a new app on the Nuc and it seemed to hang up on the Resin screen while installing (so I rebooted). Ever since then, I’ve been stuck on this “overlapping partition” issue


#8

Any thoughts? I need to utilize this device ASAP - any other way to flash?


#9

Got it - I installed Ubuntu on the box which must have fixed the partition issue and then Resin, and now it’s installng